Menu

Steps to Better Grossing

From patient to pathologist, preparing tissue specimens for histological examination requires care, skill and sound procedures. This guide provides practical advice on best practice techniques and simple ways to avoid common errors.

Tips for better grossing are highlighted in this guide. We hope each step provides a valuable reminder of good histology practice and also helps with troubleshooting when unacceptable results do occur.

Get Knowledge Pathway updates delivered directly to your inbox.

If you have viewed this educational webinar, training or tutorial on Knowledge Pathway and would like to apply for continuing education credits with your certifying organization, please download the form to assist you in adding self-reported educational credits to your transcript.

Apply for self-reported educational credits

Check Fixation Status

Specimens are dealt with promptly (especially large specimens that may otherwise be inadequately fixed).

No consideration given to optimizing the fixation of problem specimens.

Specimens in the large containers should be checked as soon as possible to ensure they will be adequately fixed.
Prepare Thin Slices

Prepare Thin Slices

Care is always taken to prepare uniform, thin slices from large specimens (3–4 mm maximum thickness). This is particularly important with dense tissues.

Slices are sometimes 6 mm (or more) thick and are often uneven.

Shown here are uniform, thin (2–3mm) slices of a tumor ready for processing. They should process effectively and should section without difficulty.
Check Fixation Status

Avoid Specimen Trauma

Care is taken to avoid traumatizing delicate specimens, particularly those that are incompletely fixed (handle carefully, do not crush, always use sharp blades).

Specimens are handled roughly without any consideration as to their state of fixation. Sometimes blunt blades are used in dissection.

 

Section of H&E stained lung showing obvious local trauma due to very forceful grasping with forceps. Fresh or partly fixed tissue is most susceptible to damage, but even well-fixed tissue can be damaged by rough handling.
Avoid Cross-contamination

Avoid Cross-contamination

Each specimen is handled on a clean surface avoiding the possibility of specimen-to-specimen contamination.

Sometimes the surface of the cutting board is not properly cleaned between specimens. This is of concern when the same specimen types are cut up one after the other. You do not want to have carry over from a specimen that is malignant to one that is benign.

Section of H&E stained lung containing a piece of foreign tissue (liver) impacted into the surface at cut-up.
Avoid Specimen Trauma

Take Care with Biopsy Pads

Fresh or incompletely fixed specimens are not placed between foam biopsy pads, particularly needle-core specimens (biopsy pad artifact is avoided).

Sometimes small, fresh or incompletely fixed specimens are placed between biopsy pads, put into a cassette and then fixed. This can produce a characteristic artifact.

 

The triangular spaces visible in this section result from local pressure effects caused by the cellular structure of the foam pads when applied to fresh or very briefly fixed tissue.
Take Care with Biopsy Pads

Choose Appropriate Cassettes

Choose appropriate cassettes for the specimen type being processed. Tissue fragments shrink during processing and, if cassette perforations are too large, fragments may escape into processing reagents or, worse still, transfer over to another specimen.

A “one size fits all” approach is used when placing specimens into cassettes.

 

A. Some of the smaller tissue fragments seen here may escape through the holes in the cassette. This will become even more likely as the tissue shrinks during processing.
B. Cassettes with fine perforations are available for small tissue fragments.
Choose Appropriate Cassettes

Avoid Overloading Cassettes

Cassettes are never overloaded with tissue thus allowing ready access to processing reagents and preventing distortion of specimens. If the volume of tissue is too great a second cassette is used.

Cassettes are often crammed full of tissue thus preventing access of processing reagents. Sometimes specimens are distorted in the process.

These cassettes are over-loaded. If processing goes ahead the specimens will be distorted and it is likely that the processing will be incomplete.
Avoid Overloading Cassettes

Clearly Label Cassettes

Cassettes are always clearly labeled. Accurate identification of specimens is of paramount importance.

Sometimes it is difficult to read the labels on cassettes. A bit of guess work may be required.

These illegible cassette labels are totally unacceptable.
Clearly Label Cassettes

本記事は、原文が英語の記事の翻訳であり、英語版と日本語版に何らかの齟齬があった場合、 英語版が優先するものといたします。

ライカバイオシステムズの「Knowledge Pathway」の記事や文書、その他一切のコンテンツは、 ライカバイオシステムズのウェブサイト 利用規約 の対象となります。ウェビナー、 トレーニングプレゼンテーションおよび関連資料を含むすべてのコンテンツは、 医療専門家が関心のある特定の主題に関する一般的な情報を提供することを目的としており、 医療、規制、または法律上のアドバイスを意図しておらず、解釈されるべきではありません。 第三者のコンテンツで表明された見解および意見は、話者/著者の個人的な見解および意見を反映するものであり、 必ずしもライカバイオシステムズとその従業員または代理人の見解ないし意見を表する、もしくは反映するものではありません。 コンテンツに含まれる第三者のリソースまたはコンテンツへのリンクは、便宜上においてのみ提供されています。 製品の使用については、製品情報ガイド、添付文書、操作マニュアルなど、該当する製品のドキュメントを参照してください。

ライカバイオシステムズおよび編集者は、記事や文書、一切のコンテンツに記載されている 薬物、デバイス、技術、または手順の使用から直接または間接的に生じるいかなる法的責任も負わないものとします。

Copyright © 2021 Leica Biosystems division of Leica Microsystems, Inc. and its Leica Biosystems affiliates. All rights reserved. LEICA and the Leica Logo are registered trademarks of Leica Microsystems IR GmbH.

Want us to feature your writing?

We are looking for more great writers to feature here. Send us a submission and we'll be in touch!

Send your Writing!

Like what you see?

Get more Knowledge Pathway content like this delivered directly to your inbox. Unsubscribe at any time.